Klipper
This guide outlines the steps and hardware needed for setting up and using a static IP address on LAN connections when using a Raspberry Pi to control your ...
Wed, 12 May, 2021 at 10:51 AM
How to enable a webcam in the mainsail ui for klipper. Click on the interface setting in the upper right corner of the webpage Next, click on the webc...
Tue, 26 Jul, 2022 at 3:36 PM
The latest Klipper update is changing how the height map/bed mesh functions work. Below is a brief explanation and a solution to keep you printing without d...
Thu, 2 Feb, 2023 at 10:58 AM
In this article, we will show you how to change the time zone on your Klipper or Octoprint install using the Raspberry Pi Software Configuration Tool or tim...
Tue, 14 Feb, 2023 at 6:49 PM
TABLE OF CONTENTS Getting Connected (Wi-Fi/Ethernet) Setting Z Offset Bed Mesh Calibration Input shaper -- Running A Shaper Tune Starting Your Firs...
Wed, 21 Jun, 2023 at 4:19 PM